Hi @Inderpreet @kodekloud-support3,
I am not able to complete the “Linux Firewalld Setup” task. Whenever I try to start the firewall service on the stapp03 server I get the error in the attachment.
Please advise.
Hi @Inderpreet @kodekloud-support3,
I am not able to complete the “Linux Firewalld Setup” task. Whenever I try to start the firewall service on the stapp03 server I get the error in the attachment.
Please advise.
HI Salim,
I am facing the same issue. How did you resolve it.
Hehehe. Salim, i was also able to resolve it by restarting dbus.
Hey guys, I am running in the following issue, even after restarting dbus.
Can you guys advise what am I missing here
I think you are running the command to restart dbus service as a normal user. Try run the same command as a root user.
salim is right, normal user have no rights to access this stuffs. so try from sudoers user and reply still facing same issue?
@Tej-Singh-Rana @ali.za.ac @Salim @ASAAC
any suggestions why the task was failed? was I supposed to input rich reject rule?
have you make it permanent ?
have you cross checked from other host server?
Hi Tej,
Yes I did make it permanent. However, was not knowing how to verify it.
Thanks
Swaroop
I have seen your other post of firewalld. You have add 2 rules in single command. May be that’s reason to failed.
And also there is no network interface associated with the public zone!
hello i don’t know why i cannot connect to any server ?
should i troubleshoot the network first ? the question is about firewalld on web servers only ?
any idea ?
It all about only targeted server which one is described in the task. You cannot access anyone of them. That’s not written in server site algorithm.