IP Table task failed. I believe i completed properly Please check

mehulr · April 17, 2020, 11:24am

Hi Kode Kloud Team,
I believe i have completed ipTable task successfully . Looks like it error out.

Thank you
Mehul

Tej-Singh-Rana · April 17, 2020, 7:32pm

what is the error output?

mehulr · April 18, 2020, 9:09pm

i was trying to say: I had completed the job , but looks like during the validation at your end something happened and it registered as i did not complete successfully.

i have all the screen log, including commands i executed. . Please let me know if you need it

thank you

mehulr · April 22, 2020, 10:46am

@Inderpreet would you please look at this one

Inderpreet · April 22, 2020, 11:32am

@mehulr seems to be some connectivity issue. You can try this task again, its in Pending state for you now.

mehulr · April 22, 2020, 1:00pm

yes, i see it is pending. Thank you Inderpreet .

Narendra096 · April 22, 2020, 8:29pm

@Inderpreet @admins
Not sure why task got failed. please verify below screenshots and let me know the conclusion.

Tej-Singh-Rana · April 23, 2020, 1:51pm

@Narendra096 but you have not set open connection for particular ip addr. It’s open for all.

Narendra096 · April 23, 2020, 6:55pm

Hello @Inderpreet @Tej-Singh-Rana ,

but in question it was mentioned that you have to block or allow traffic for a specific Port(in this case apache and nginx ports) not for specific IP.(this is not the 400 points(firewalld setup) question. its application security one). i hope i am clear.
please let me know if i made any mistake.

Devops · April 23, 2020, 8:28pm

What’s happened!!!
KKE: ismail